- #XBOX 360 CONTROLLER OR XBOX ONE CONTROLLER FOR PC HOW TO#
- #XBOX 360 CONTROLLER OR XBOX ONE CONTROLLER FOR PC SERIAL#
- #XBOX 360 CONTROLLER OR XBOX ONE CONTROLLER FOR PC UPDATE#
- #XBOX 360 CONTROLLER OR XBOX ONE CONTROLLER FOR PC ARCHIVE#
Basically, follow the picture (click for bigger image):īeginner’s mistake/brain fart moment warning: Make sure the diode is the right way around. Instead I’ll assume you’re sitting there with an RF board, a USB cable ready for soldering, a diode, and a hot soldering iron.
#XBOX 360 CONTROLLER OR XBOX ONE CONTROLLER FOR PC HOW TO#
And that’s your part.Īs you’re reading this and have an interest in it I’ll assume you know how to cut, strip, and tin your wires, so I’ll not bother with that part. Don’t go trying to pry it off like I almost did. It’s held on by 3 screws, so be sure to pop the little plastic part off to find the third screw. It’s the board on the front of the machine where the ring and power button are. Pro tip: Instead of a small plastic knife that they say to use to ping open the case, you can either buy a tool for it, make one out of an old CD/DVD spindle cover, or just rip the damn thing open with a screwdriver (after all, it’s dead right?). has a perfectly good explanation of how to do this. I’m not going to reinvent the wheel here. Basically it’s just there for a forward voltage drop WHICH IS VITAL (unless you don’t mind burning the board out and killing your USB controller).
#XBOX 360 CONTROLLER OR XBOX ONE CONTROLLER FOR PC UPDATE#
Update 5: Further testing on alternative syncing method shows how non-play & charge kit compatible peripherals can be synced -without- a microcontroller.
Update 4: Alternative means of syncing mentioned in the comments by George. You can find the related forum post here: Link (and see how my thrown together version of it looks and.
#XBOX 360 CONTROLLER OR XBOX ONE CONTROLLER FOR PC SERIAL#
However, I am working with another modification I found which adds LED and sync enable functions by means of a serial connection with a PIC16F628A μC. Update 2: It seems that syncing is impossible directly from the RF module and PC, but if the wireless controller you use was already synced with the RF module, and hasn’t been re-synced with another Xbox since, it will work. I also added actual photos of the wiring now, as I’ve redone it (hence the messy wires from re-soldering Etc.) Two diodes in series take the voltage down to almost exactly 3.3V, which is the required voltage for the RF board. Update: I updated the post to mention using two 1N4001 or equivalent diodes instead of just one.
#XBOX 360 CONTROLLER OR XBOX ONE CONTROLLER FOR PC ARCHIVE#
Please note that I barely pay attention to this site anymore and is only here for archive purposes.